PowenKo > Arduino > motor

February 12, 2012   ·   0 Comments

IMAG2258 copy



// Sweep
// by BARRAGAN <http://barraganstudio.com> 
// This example code is in the public domain.


#include <Servo.h> 
 
Servo myservo;  // create servo object to control a servo 
                // a maximum of eight servo objects can be created 
 
int pos = 0;    // variable to store the servo position 
 
void setup() 
{ 
  myservo.attach(9);  // attaches the servo on pin 9 to the servo object 
} 
 
 
void loop() 
{ 
  for(pos = 0; pos < 180; pos += 1)  // goes from 0 degrees to 180 degrees 
  {                                  // in steps of 1 degree 
    myservo.write(pos);              // tell servo to go to position in variable 'pos' 
    delay(15);                       // waits 15ms for the servo to reach the position 
  } 
  for(pos = 180; pos>=1; pos-=1)     // goes from 180 degrees to 0 degrees 
  {                                
    myservo.write(pos);              // tell servo to go to position in variable 'pos' 
    delay(15);                       // waits 15ms for the servo to reach the position 
  } 
} 
shareShare on FacebookShare on Google+Share on LinkedInEmail this to someonePrint this pageBuffer this pageDigg thisFlattr the authorShare on RedditPin on PinterestShare on StumbleUponShare on TumblrTweet about this on Twitter

By


Readers Comments (0)


You must be logged in to post a comment.

PowenKo’s Online Store

powenko_arduinoBook
Hardware22

Hardware

Amazon

adsbygoogle

Recent Posts

Categories

Amazon