arduino xbee, send On /Off LED

August 15, 2012   ·   1 Comments

IMAG3000 copy

server code


const int ledPin = 13; // the pin that the LED is attached to
int incomingByte;      // a variable to read incoming serial data into

void setup() {
  // initialize serial communication:
  Serial.begin(9600);
  // initialize the LED pin as an output:
  pinMode(ledPin, OUTPUT);
}

void loop() {

   Serial.print('H');
      digitalWrite(ledPin, HIGH);
      delay(500);

   Serial.print('L');
      digitalWrite(ledPin, LOW);
      delay(500);

}

client code


const int ledPin = 13; // the pin that the LED is attached to
int incomingByte;      // a variable to read incoming serial data into

void setup() {
  // initialize serial communication:
  Serial.begin(9600);
  // initialize the LED pin as an output:
  pinMode(ledPin, OUTPUT);
}

void loop() {
  // see if there's incoming serial data:
  if (Serial.available() > 0) {
    // read the oldest byte in the serial buffer:
    incomingByte = Serial.read();
    // if it's a capital H (ASCII 72), turn on the LED:
    if (incomingByte == 'H') {
      digitalWrite(ledPin, HIGH);
    }
    // if it's an L (ASCII 76) turn off the LED:
    if (incomingByte == 'L') {
      digitalWrite(ledPin, LOW);
    }
  }
}

shareShare on FacebookShare on Google+Share on LinkedInEmail this to someonePrint this pageBuffer this pageDigg thisFlattr the authorShare on RedditPin on PinterestShare on StumbleUponShare on TumblrTweet about this on Twitter

By


Readers Comments (1)

  1. Alan

    This is a very good website.

    »

You must be logged in to post a comment.

PowenKo’s Online Store

powenko_arduinoBook
Hardware22

Hardware

Amazon

adsbygoogle

Recent Posts

Categories

Amazon